Fluke 45 Instrukcja Użytkownika Pobierz pdf (Strona 88)

Operating the Meter Using the Computer Interface

Computer Interface Command Set

5-29

RS-232 Remote/Local Configurations

The commands in Table 5-18 are used with the RS-232 interface to set up the Remote/ Local

configuration of the meter. These commands are valid only when the RS-232 interface is

enabled.

Table 5-18. Remote/Local Configuration Commands

Command Description

REMS

RWLS

LOCS

LWLS

Puts the meter into the IEEE-488 REMS state, i.e., IEEE-488 remote operating mode

without front panel lockout. "REMOTE" is shown on the display.

When in the IEEE-488 REMS state (remote): pressing S (LOCAL) returns the

meter to local (i.e., front panel) control; pressing T triggers a measurement if

external triggering is enabled. All other front panel buttons are disabled.

Puts the meter in the IEEE-488 RWLS state, i.e., IEEE-488 remote operating mode

with front panel lockout. "REMOTE" is shown on the display. When in RWLS, all front

panel buttons are disabled.

Puts the meter in the IEEE-488 LOOS state, i.e., local operating mode without

lockout. All front panel buttons are enabled.

Puts the meter in the IEEE-488 LWLS state, i.e., local operating mode lockout. All

front panel buttons are disabled.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 121 122

Brak uwag

Fluke 45 Instrukcja Użytkownika Strona 88